Skip to content

Readability Improver: How to Make Any Text Easier to Read

What Does a Readability Improver Do?

A readability improver goes beyond measuring readability — it identifies the specific problems dragging your score down and suggests concrete fixes. While a Readability Checker tells you "your Flesch score is 42 (Difficult)," a readability improver tells you "sentence 7 is 38 words — split it" and "replace 'utilize' with 'use.'"

Get actionable improvement suggestions with WritePadPro's Readability Improver — it analyzes your text and provides specific, sentence-level recommendations for simplifying complex sentences, replacing wordy terms, and rewriting passive voice.

The difference between diagnosis and treatment matters. Most writers know their readability score is too high. Few know exactly which sentences and which words are causing the problem. A readability improver bridges that gap by pinpointing likely problems and suggesting a fix — turning a vague "write more simply" directive into a specific, executable editing checklist.

Complex Word Replacement

Multi-syllable words are the fastest way to inflate readability difficulty. Every extra syllable increases your average syllables per word (ASW), which directly raises Flesch-Kincaid scores. WritePadPro's Readability Improver checks your text against a list of about 100 wordy terms, such as "utilize" and "facilitate," and suggests a plainer word for each one it finds. The table below shows common swaps; not every word in it is on the tool's list.

The Most Common Replacements

Complex WordSyllablesSimple AlternativeSyllablesSavings
utilize3use1-2
demonstrate3show1-2
approximately5about2-3
facilitate4help1-3
subsequently4then1-3
nevertheless4still / but1-3
communicate4tell / share1-3
implement3do / run1-2
methodology5method2-3
prioritize4rank / focus1-3
significantly5greatly / much1-2-3 to -4
comprehensive4complete / full1-2-2 to -3
consequently4so1-3
accommodate4fit / hold1-3
functionality5feature2-3

When NOT to Simplify

Not every complex word should be replaced. Technical terms that your audience understands ("algorithm" for developers, "diagnosis" for medical professionals) should stay. Precision matters — "terminate" and "end" are not always interchangeable in legal contexts. The rule: simplify when a simpler word conveys the same meaning without losing precision. See our Readability Score Guide for more on how word complexity drives scores.

Long Sentence Splitting

Average sentence length is the other primary driver of readability scores. The Readability Improver flags sentences over 25 words and marks those over 30 words as high priority. These four techniques cover most splits.

The 4 Splitting Techniques

1. Split at Conjunctions

Before (27 words): "The marketing team completed the quarterly report and submitted it to the executive committee, who reviewed the findings and approved the budget for the next fiscal year."

After (14 + 12 words): "The marketing team completed the quarterly report and submitted it to the executive committee. The committee reviewed the findings and approved the next fiscal year's budget."

2. Remove Relative Clauses

Before (25 words): "The software platform, which was originally designed for enterprise clients who needed real-time analytics capabilities, has since been adapted for small business and individual users."

After (12 + 10 words): "The software platform was originally designed for enterprise clients needing real-time analytics. It has since been adapted for small businesses and individuals."

3. Separate Cause and Effect

Before (24 words): "Because the server experienced unexpected downtime during peak hours, the development team decided to implement a redundant failover system to prevent future service interruptions."

After (8 + 12 words): "The server experienced unexpected downtime during peak hours. The development team implemented a redundant failover system to prevent future interruptions."

4. Extract Parenthetical Information

Before (28 words): "The Flesch-Kincaid Reading Ease formula, developed by Rudolf Flesch and later adapted by J. Peter Kincaid for the United States Navy, produces a score between 0 and 100."

After (12 + 16 words): "The Flesch-Kincaid Reading Ease formula produces a score between 0 and 100. It was developed by Rudolf Flesch and adapted by J. Peter Kincaid for the U.S. Navy."

Each split lowers your average sentence length a little, and in a long article the effect adds up across every sentence you split. Use the Grammar & Spell Checker after splitting to verify that the new sentences are grammatically sound.

Passive to Active Voice Conversion

Passive voice adds unnecessary words and reduces clarity. The Readability Improver flags likely passive constructions (one per sentence) and shows the sentence so you can rewrite it with the actor as the subject. It does not rewrite the sentence for you.

How to Identify Passive Voice

Passive voice follows the pattern: subject + form of "to be" + past participle. The simple test: can you add "by zombies" after the verb? If yes, it is passive.

  • "The report was written [by zombies]" → passive
  • "The team wrote the report" → active ("The team wrote [by zombies]" does not work)

Common Passive → Active Conversions

Passive (words)Active (words)Savings
The data was analyzed by researchers (6)Researchers analyzed the data (4)-2
Mistakes were made by the team (6)The team made mistakes (4)-2
The decision was approved by the board (7)The board approved the decision (5)-2
The document has been reviewed and signed (7)We reviewed and signed the document (6)-1
It was determined that changes were needed (7)We determined that changes were needed (6)-1

When Passive Voice Is Correct

Passive voice is not always wrong. Use it when:

  • The actor is unknown: "The window was broken" (by whom? Unknown.)
  • The actor is irrelevant: "The experiment was conducted at room temperature" (who conducted it matters less than the conditions).
  • The receiver is more important: "The patient was diagnosed with pneumonia" (the patient matters more than which doctor).
  • Diplomatic phrasing is needed: "Errors were found in the report" (avoids blaming a specific person).

A common rule of thumb is to keep most sentences active and use passive voice only where it serves the reader. For a complete guide on active vs passive voice, see our Active vs Passive Voice article. For vocabulary-level analysis, the Vocabulary Analysis Guide provides deeper metrics.

Jargon and Technical Language Detection

Jargon is specialized vocabulary that insiders understand but outsiders do not. WritePadPro's Readability Improver does not detect jargon: its word list covers general wordy terms, not field-specific vocabulary. Use the audience test below to catch jargon yourself.

Categories of Jargon

TypeExamplePlain Alternative
Business jargon"leverage synergies""combine strengths"
Business jargon"circle back""follow up"
Business jargon"move the needle""make a difference"
Tech jargon"deploy to production""launch" or "go live"
Tech jargon"refactor the codebase""restructure the code"
Marketing jargon"top of funnel""early-stage awareness"
Marketing jargon"conversion optimization""improving sign-ups/sales"
Academic jargon"operationalize the construct""define how to measure it"
Legal jargon"notwithstanding the foregoing""despite what was said above"

The Audience Test

Before using any specialized term, ask: "Would my target reader understand this without a definition?" If the answer is no, either replace it with a plain-language equivalent or define it on first use. Writing for experts does not require jargon — it requires precision. The most respected experts explain complex ideas in simple language.

Before/After: Full Document Makeover

Here is a short paragraph transformed using all four improvement techniques — word simplification, sentence splitting, passive-to-active conversion, and jargon removal.

Before (Flesch-Kincaid Grade 21.7, Flesch Reading Ease 0 — Very Difficult)

"The implementation of the aforementioned methodology was subsequently undertaken by the research team, who endeavored to utilize a comprehensive analytical framework that had been previously established by Smith and colleagues (2019). It was determined that the methodology demonstrated significant efficacy in facilitating the identification of patterns that were consistent with the hypothesized outcomes. Nevertheless, it should be noted that additional investigation is necessitated to comprehensively validate the preliminary conclusions that were obtained during the initial phase of the investigation."

79 words, 3 sentences, avg 26.3 words/sentence, 2.29 syllables/word (measured with WritePadPro's Readability Checker)

In the Readability Improver, this paragraph gets 12 suggestions: a very long sentence (31 words), a long sentence (26 words), two passive constructions and eight wordy terms, including "utilize" and "methodology."

After (Flesch-Kincaid Grade 8, Flesch Reading Ease 55.7 — Fairly Difficult)

"The research team applied Smith's analytical framework (2019). The method worked well for finding patterns that matched the expected outcomes. However, more research is needed to confirm these early results."

30 words, 3 sentences, avg 10 words/sentence, 1.67 syllables/word

What Changed

  • "implementation of the aforementioned methodology was subsequently undertaken" → "applied" (word simplification + passive to active)
  • "endeavored to utilize a comprehensive analytical framework" → "analytical framework" (jargon removal)
  • "demonstrated significant efficacy in facilitating the identification" → "worked well for finding" (simplification)
  • "it should be noted that additional investigation is necessitated" → "more research is needed" (simplification; "is needed" is still passive, a reasonable one to keep because the actor does not matter)
  • 79 words → 30 words (a 62% cut, with the main points kept)

The improved version keeps the main points in fewer than half the words, and its grade level drops from about 22 to 8. Its Flesch Reading Ease score (55.7) is still "Fairly Difficult," mostly because of longer words such as "analytical," so a version for a general audience could go further. After revising, check for errors introduced during editing; the Grammar Mistakes Guide lists the common ones.

Using WritePadPro's Readability Improver

WritePadPro's Readability Improver combines analysis with actionable suggestions.

Step 1: Paste Your Text

Open the Readability Improver and enter your content (at least two sentences), then click Analyze Readability.

Step 2: Review the Suggestions

WritePadPro identifies and flags:

  • Long sentences — sentences over 25 words, shown with their word count and a prompt to split them (over 30 words is high priority)
  • Passive voice — likely passive constructions, with the sentence shown so you can rewrite it
  • Long paragraphs — paragraphs of six or more sentences
  • Complex words — wordy terms from a list of about 100, each with a plainer alternative
  • Filler adverbs and repeated openings — words like "very" and "really" once they pass 3% of your text, and three or more sentences that start with the same word
  • Flesch Reading Ease — one baseline score with a grade-level label (the Readability Checker shows all six formulas)

Suggestions are color-coded and sorted by priority: high, medium, then low.

Step 3: Apply the Fixes

Work through the suggestions systematically. Start with the easiest wins: replace complex words with suggested alternatives. Then split flagged long sentences. Then convert passive constructions. Each fix incrementally improves your readability score.

Step 4: Measure Improvement

After applying fixes, click Analyze Readability again and compare the new Flesch score with the old one. Copy Report saves a plain-text list of the suggestions if you want to keep a record.

Summary

A readability improver turns vague "write more simply" advice into specific, actionable fixes. The four pillars of readability improvement are: replacing complex words with simpler alternatives (targeting 1.4-1.6 syllables per word), splitting long sentences (targeting 15-20 word average), converting passive voice to active (keeping most sentences active), and eliminating jargon (replacing insider terms with plain language).

The before/after makeover shows what systematic editing can do: the same content, cut from 79 words at a Flesch-Kincaid grade of about 22 to 30 words at grade 8, with the main points kept.

Get specific, sentence-level improvement suggestions with WritePadPro's Readability Improver — it flags long sentences, likely passive constructions and wordy terms from its list, and suggests what to change.

Frequently Asked Questions

What is the difference between a readability checker and a readability improver?

A readability checker measures your text's difficulty and produces scores (Flesch-Kincaid, Gunning Fog, etc.) — it tells you what your readability level is. A readability improver goes further by identifying the specific sentences and words causing the difficulty and suggesting concrete fixes: 'Split this 35-word sentence,' 'Replace utilize with use,' 'Convert this passive construction to active.' The checker is the diagnosis; the improver is the treatment. WritePadPro offers both tools for a complete readability optimization workflow.

How much can I improve my readability score in one editing pass?

It depends on where you start, so there is no typical number. The fastest gains come from two actions: splitting sentences over 25 words and replacing multi-syllable words with simpler synonyms, because sentence length and syllables per word are what the Flesch formulas measure. Run the Readability Improver before and after each pass; its Flesch score shows how much each round of edits helped.

Should I always replace complex words with simpler ones?

No. Replace complex words when a simpler word conveys the same meaning without losing precision. 'Utilize' and 'use' mean the same thing — always choose 'use.' But 'algorithm' has no simpler equivalent that conveys the same technical meaning — keep it when writing for a technical audience. The rule is: simplify when the simpler word works just as well. Keep the complex word when it adds genuine precision that the simpler alternative lacks. Never use a complex word purely to sound sophisticated.

Why does the Readability Improver flag some passive sentences that read fine?

Its passive check is rule-based. It looks for a form of "be" (am, is, are, was, were, be, been, being), optionally one adverb, then a past participle, and flags one match per sentence. So "The store was closed" is flagged even when "closed" describes the store, while passives built without "be," such as "got delayed," are missed. Common -ed adjectives such as "excited" or "tired" count only when "by" follows. Treat each flag as a prompt: keep the passive when the actor is unknown or does not matter, and rewrite it when hiding the actor makes the sentence vague.

Try These Tools

Related Articles